Commen Questions & Solutions

Prev Next
  • Published on May 12, 2025
Push arm Make sure the wave as the image shows Pull arm Make sure the curve is pointed in. Pull Z arm
  • Published on May 12, 2025
Caution *** This type of problem will only appear on pull installation which is using pull arm.** First Solution 2 Inches Installation (Suggestion Second Solution Fill up the pull arm track Straight fill up the gap between track ...
  • Published on May 12, 2025
When the door is fully closed, manually push the door and the door operator will automatically open the door. Step 1: Select MENU on the control board and go all the way to the last options. ( Setting 29 ) Step 2: Press an...
  • Published on May 12, 2025
**During the door opening cycle, if the power accidently cut off, we want the door close slowly instead of smashing. ** Short circuit the MOTOR RESIST
  • Published on May 12, 2025
Step 1: Select MENU on the control board and go all the way to the last options. ( Setting 29 ) Step 2: Set Factory Test parameter from 0 to 3. Step 3: Select MENU again, the door operator will reset to default.
  • Published on May 12, 2025
This is because when you were installing the arm, the spindle did not fully open to hard stop. Step 1: Factory rest the door operator. Please see the FAQ " How to do factory reset " Step 2: Uninstall the arm. Step 3: Follow the FA...
  • Updated on May 13, 2025
  • Published on May 12, 2025
Possible reason 1. installation issue: the Header is not follow the instruction to install. solution: For pull application We suggest install the door operator 2 inches above the door. Please see the FAQ " How to install the door opera...
  • Updated on May 13, 2025
  • Published on May 12, 2025
Scenario 1: The door is hard to open and the lock tongue jammed with the strike : SOLUTION: Preload This will lead the door open a small gap and stop or clamp by the door strike. Increase the preload time. Please see the FAQ " Special Sce...
  • Updated on May 13, 2025
  • Published on May 12, 2025
Strong winds can cause the door to open too quickly or with excessive force, which might put undue stress on the mechanical components, such as the gearbox or motor. **This means that if you open the door in a location where the wind mig...
  • Updated on May 13, 2025
  • Published on May 12, 2025
Solution 1: Overload Increase the overload value Please see the FAQ " Parameter List & Descriptions " for detail information. Solution 2: Quick Open - 0 slow ramp from full close Change the parameter from 1 stander to 0...
  • Updated on May 13, 2025
  • Published on May 12, 2025
There are multiple reasons that the door cannot be fully closed. Reset the door operator before any reinstallation or parameters setup error. Please read through the FAQ " How to do factory reset " The door clamp by the door strike. Ma...