Power-On Operation

1. Power on the device with 12V/1A power supply and wait until the device Call button light turns

RED breathing light and hear the bee tone from El2W.

(RED)

Wi-Fi Configuration

(BLUE WIFI)

2. Press the Tamper-proof button three times to enter the the Wi-Fi scanning mode as indicated by the BLUE flashing light on the card reader area. And wait until the BLUE light stays constant ,when the device has finished Wi-Fi scanning and entered Network Pre-configuration mode, which lasts for only 20 seconds before it expires.

Tamper-proof button

3. Before Network Pre-configuration mode expires, long press the Call button for 3 seconds to enter the Network Configuration mode, when the device will automatically enable its hotspot feature while creating a hotspot access connection named E12-XXXX with no access password. "XXXX" is the last four digits of the device's MAC address.

(Call button)

4.0pen the WLAN feature on your mobile phone, find the Wi-Fi named "El2-xxxx", click "connect". During this process, the Call button BLUE light will keep flashing. And now you will have only 5 minutes to finish the device Network configuration on your mobile phone via Hotspot, because both the Network Pre-configuration mode and Network Configuration mode will expire in 5 minutes.

(BLUE)

5. After your mobile phone is connected to the hotspot successfully, your mobile phone will automatically open the browser and enter the Wi-Fi Configuration page. You can also type the hotspot IP address 192.168.188.10 on the mobile phone's browser to enter the configuration page. Now, you can select the Wi-Fi network you want the device to be connected to, and enter the corresponding Wi-Fi password, and tap Connect button.

6. During connection process, the Call button BLUE light keeps flashing. If successfully connected to the Wi-Fi, you will see the Call button BLUE light stays on and hear prompt sound for the successful connection. If the connection failed, you will see PURPLE flashing light, requiring you to proceed from step 1.

Note: 

In this step, you can always press Tamper-proof button 3 times to proceed from the step 1. 

If anything goes wrong such as having entered the incorrect password.

BLUEPURPLE

(BLUE)(PURPLE)

Indicator Light

Mode	Indicator Status
Power on without network	Call button: Red light flashes once every 400ms
Wi-Fi scanning mode	Card reader area: flashes once every 400ms. Call button: always off
Pre-configuration mode	Card reader area: always on Call button: always off
Network configuration mode	Card reader area: always off Call button: Blue light flashes once every 400ms
Connect Wi-Fi	Success: Card reader: always off Call button: blue light is always on Failed: Card reader: always off Call button: Purple light keeps flashing for 400ms

Notice Information

Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox' s website: http://www.akuvox: mm© Copyright 2021 Akuvox Ltd. All rights reserved.

AKUVOX (XlAMEN) NETWORKS CO., LTD.

ADD: 10/F, N0.56 GUANRl ROAD, SOFTWARE PARK 11, XIAMEN 361009, CHINA

www.akuvox.com